Support VWWC

Page 1 of 2 12 LastLast
Results 1 to 10 of 11

Thread: Firewall Mk3

  1. #1
    Join Date
    Jan 2006
    Location
    Brisbane
    Posts
    374
    Users Country Flag

    Firewall Mk3

    Folks, where on the firewall do you run the power to your amps? Also where do you mount yr amps? I have vr6 seats on the lowest setting and am installing a 4 channel Alpine V12?

    Cheers

    Luke

  2. #2
    Join Date
    Oct 2006
    Location
    Sydney
    Posts
    1,440
    I know theres a small grommet on the passengers side which u can take off and run a wire to the battery. The rubber grommet is attached to a plastic tubing? thru to the dash but u can leave it hanging and plug the hole with something else.

    I dont have an amp so cant comment on best place to mount but ive seen many installed into the boot.

  3. #3
    Join Date
    Feb 2007
    Location
    Bunyip, Victoria
    Posts
    843
    I have 2 amps in mine, both are mounted under a faulse floor in the boot. Anouther good place for them is mounted to the backs of the rear seats.

    Let us know how you go.


  4. #4
    Join Date
    Sep 2006
    Location
    Parkinson / Brisbane
    Posts
    2,443
    Users Country Flag
    Will take some pics for you tmozza

  5. #5
    Join Date
    Feb 2007
    Location
    Perth, WA
    Posts
    2,360
    Back of the rear seat for me with my amp.

    There aint no space under them seats!

    Couldnt tell you about the power cable. Had it done "professionally" *cough*.
    1996 Golf VR6 Colour Concept Green

  6. #6
    Join Date
    Sep 2006
    Location
    Parkinson / Brisbane
    Posts
    2,443
    Users Country Flag
    I'll post'em up this arvo . . .

  7. #7
    Join Date
    Feb 2007
    Location
    Bunyip, Victoria
    Posts
    843
    I knew i had a pic somwhere.

    If you follow the looms down you will find where i entered the firewall.


  8. #8
    Join Date
    Jan 2006
    Location
    Brisbane
    Posts
    374
    Users Country Flag Thread Starter
    Sweet.. thanks a lot Science VR6....

    Alex I eagerly await your pics...

  9. #9
    Join Date
    Sep 2006
    Location
    Parkinson / Brisbane
    Posts
    2,443
    Users Country Flag
    haha, damb im a lazy... . . .

    The install, not that cosmetically pleasing but is all dead center of the car soze not lopsided . . .
    Attachment 784

    I've pretty much ran the power cable along with the factory loomz . . .
    Attachment 785

    as previously mentioned, theres a gromet up there, go through that . . .
    Attachment 786
    Attachment 787

    Den there's another one tucked up in there that will grant you access into the cabin through your firewall . . .
    Attachment 788

    Hope it helps! and good luck

    Laterzzz . . . Alex

  10. #10
    Join Date
    Nov 2005
    Location
    Sydney NSW
    Posts
    325
    Users Country Flag

    I stuffed my 4 Gauge Power Cable cable down the side of the top strut tower next to the fender on the LHS of the car. I had to drill a hole in the rain shield for the cable and a grommet. Then ran the cable up the side of the pollen air filter box and I think another drilled hole and grommet. You will have to take the pollen filter box out to do the work. Then inside the car the cable pokes through the firewall at the far LHS behind the Airbag. I then run it down the kick panel between the chassis and the brackets for the dash. You then run it under the kick panel and into the lower door frame tunnel... this then exits under the rear seat and then you just feed it where ever to the rear where you mount your amps... I also did the same to the RHS of the car for my 3 pairs of RCA cables.
    \( O ) o\====(\X/)=TDI=/o ( O )/ 2011 Jetta Mk5 125TDI - Squidly

    ((o)(O))====(\X/)=TDI=((O)(o)) 1996 Golf Mk3 TDI - Squid

Page 1 of 2 12 LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
| |