It Begins: The S3 1.8T into my '85 Mk2 GTI

[h100vw]

Result Wade. Good score on that stuff from the UK too mate.

Gavin

[GOLFBALLS]

Here's the plot readout. You can see where the power was on the old lean mix run on the faint lines. It made about 235hp at the wheels before, but now its over rich and peaks at about 205hp at the wheels. At least its safe to run on boost till it gets tuned properly in the new year! Sure beats driving around with 180hp and only wastegate boost!!!!

You can really feel the power dip when driving too.



Then we wired in the thermofan to the ECU, but we couldn't figure out how to set it in the retarded easimap software to actually come ON when it hit 70 degrees!


We'll have another chat with the QPEng guys and get them them to send a revised base map while they're at it.

So thats about it till next year. I'm headin to Melbs & Tassie over xmas/ny so be nice to have a rest!

Cheers,
Wade

[GOLFBALLS]

Result Wade. Good score on that stuff from the UK too mate.

Gavin

Yea cheers Gavin.
Its nice to know that if anything goes bang I have almost an entire spare engine! Just need a block and pistons..

[Volksee77]

nice work Wade, it'll be nice with the torque on roll on hey

[roccodingo]

Good score Wade, now you can enjoy the xmas break !!!

[GOLFBALLS]

Good score Wade, now you can enjoy the xmas break !!!

Hell yea!!

I'll come down and give back your pressure reg too mate. Didn't end up needing it.

I also found the spare immobiliser button for the cordoba!

Cheers,
Wade

[MattyT]

Any news wade?

[GOLFBALLS]

Not much dude.
I emailed the latest dyno plot to qpeng and they've emailed back a revised base map. Just gotta find time/money to get back to the tuners. I also desperately need new tyres!!!

[GOLFBALLS]

A few things have been bubbling away since the last post guys.
Long story short, Qpeng sent a revised map to counter the overfuelling which suddenly started after installing the 044 fuel pump.
We loaded it onto the ECU and guess what?! It went back to behaving just like it was in the beginning - lean as 5h!t!

So then we thought 'oh well we'll reload the setting from when I came in this morning and just manually tune it out'. Well, then that map wouldn't load back up onto the ECU.

Not only that, but the thermofan won't bloody run either. It's wired up and runs, but when you set it up through the ECU it just never comes on - even in 'continuous test mode'. FFFFFUUUUUUUUUUUCCCCCKK!!!!!!!!!!!!!!!!!!!!!!!!!!! !!!!!!!!!!

So. Dave at R P W (my tuner) reckons we can use a haltech E6X, Platinum sport 500 or Platinum Sport 1000.

I'm looking at somewhere between $2000 - $2700 installed and tuned. The E6X will basically plug straight into the mbe/QPEng harness plug, but its no longer in production, and if i use the Sport 1000 there's just a few wiring pin changes and i can actually run the sequential injection and variable valve timing too, which is not possible with the qpeng setup or the E6X.

If i can get some kind of refund from qpeng for the ecu I might go the sport 1000....

decisions decisions..

[Volksee77]

hmmmm well wade i happen to have a brand new Haltech E6X in the box in my shed with a full harness, how much are you looking to pay for one? I reckon I could sell it to you quite a bit cheaper than the 2K for a newer version? Let me know if your keen.
Luke