Stud pattern shared with Nissan?

**Lemon** · 25-06-2011, 11:02 PM

Hey all, long shot yes but I just picked up a new mk1 golf and I have the opportunity to pick up some demons wheels I used ton Which will be comming off an r31 skyline. I don't have the wheels here to check but is theirany smart cookies who can tell me if they share patterns (vw to nissan) and what my chances are of them fitting?

**Lemon** · 25-06-2011, 11:04 PM

Sorry, phone spell check: demons= Renoma

**schoona** · 25-06-2011, 11:24 PM

The mk1 will be 4 x 100. The R31 5 x 114.3

Use ECS or adaptec speedware to source adapters. Much easier if the wheels are higher offset (the ET number closer to 50 than 0 for example) to give you space to use the adapters (obviously going to push the wheel face outward towards the guards (or past it))

**Lemon** · 25-06-2011, 11:39 PM

31s are 4 stud, or am I reading that wrong

**Blitzen** · 26-06-2011, 12:02 AM

R31 Skylines are 4 x 114.3, and as stated above, Mk 1 Golfs are 4 x 100....

**Lemon** · 26-06-2011, 12:37 AM

They would look hot on my yellow MK1 if I could somehow make it work. Will try to find out the ofset

**schoona** · 26-06-2011, 09:13 AM

Originally Posted by Blitzen

R31 Skylines are 4 x 114.3, and as stated above, Mk 1 Golfs are 4 x 100....

Fat fingers

yeah 4x114.3 on the R31

**Lemon** · 26-06-2011, 11:33 AM

how much would adaptors set me back do ya think?

**Jarred** · 26-06-2011, 12:25 PM

dapters are around 400-450 landed from the US.

another possibility is to have the wheels filled and drilled. can be expensive depending where you get it done, but i think you'll find R31's have low offset wheels, which means adapters are out of the question.