Originally Posted by
defie
anyway to make it fit inside the bodywork?
A wheel specialist should be able to machine the inner face of the wheel hub if there is sufficient metal to work with. It will depend how deep they have drilled the clearance holes for the wheel bolts.
I know a couple of places in Sydney that can do it. Vic should have a few too. Even a machine shop could do it but they might not know how much metal you need to stop the bolts from pulling through.
Angles on the photos don't really tell how bad it is
carandimage The place where Off-Topic is On-Topic
I used to think I was anal-retentive until I started getting involved in car forums
Bookmarks