16" wheels for a mk3

[WABIT]

try here

awesome manufacturing and build quality!!!

http://www.vwwatercooled.org.au/newf...ad.php?t=11747

and will be cheap also

wabit

[Golf Houso]

Yeah I understand, but when you've gone through what I have. Trying to maintain and bring a car back to scratch on pocket money and loose change whilst studying at uni, you get over spending money on a car to a certain point.

I love my car, but only as a vehicle and a mode of transport. I've understood the value of it and what it can offer, but I'm never going to be a slave to it either ever again.

But yeah, if you can get some money back go ahead. But I'm really, really over it. I'm making a great income but none of it at all is going back into the car, not a cent. But if you love it... do it. And I'd love to see the results.

Lol 8 inch staggered... thats massive man!

[BBS_mk3]

Yeah actually I quite like these ones 1i 16x7.....



I noticed the ET is 40. Since that's a higher possitive number than factory, that means the wheel will sit into the wheel arch more right??? Do you reckon it will sit in too far? Are wheel spacers themselves illegal to use or is it just the stud patten converting spacers that are illegal?

try here

awesome manufacturing and build quality!!!

http://www.vwwatercooled.org.au/newf...ad.php?t=11747

and will be cheap also

wabit

[WABIT]

all spacers are illegal... but not really dangerous like the converter spacers
im pretty sure there will be no problem in touching anything but
if you get 5 or 8mm spacers all round it will be fine

wabit

[Tim]

the mounting face will sit in further if theyre the same width. But theyre wider than your stock rims

Say the rim is an extra 1 inch wider. Thats 25.4mm. If you halve that. Thats how much futher out the rim will poke on each side of the mounting face. Then you adjust for the difference in offset.

[peedman]

Hehehe i might be getting my hands on some 16x7 and 16x8 wheels . Not letting the cat out of the bag but they are sweetness!

[IbizaGTI]

I've been looking at 16"s for my Ibiza, had a look through the Rota site and picked a couple I think I like:


Rota J-mag in Red


Rota GT3 in steel grey

but I think these CSA's look the biz! any opinions?


CSA Race
http://www.mullins.com.au/wheel-range.asp

PS
excuse the quick photoshoping
and I hope I haven't stolen the thread - I figured everyone could benefit from my research...

[peedman]

Hmmm for the ibizas i prefer flat multi spoked. Something similar to the CSA's would look good imo, it may be just ur bad photoshop but those ones look a bit funny lol.

[BBS_mk3]

It looks like the decision may have been made for me....I was just sandwiched in a car accident and I think the car may be a write off

all spacers are illegal... but not really dangerous like the converter spacers
im pretty sure there will be no problem in touching anything but
if you get 5 or 8mm spacers all round it will be fine

wabit

[madglf3]

Nooooooooo!!! not the Mk3, your one from the looks of it looked very clean. Are you at least ok physically?

I hope it all goes well for you man, good luck with it all