I have done some preliminary edits on the spreadsheet - for one I think we need to separate bugs and features, so I have added a missing features sheet within the document, but I've left the original sheet as it was. I still need to compare the sheet properly with my own notes that I've made over time. I also have not been able to answer everyone's messages / emails yet so I will continue that tomorrow.
For now the updated firmware can be found here:
https://dl.dropboxusercontent.com/u/...S_20131129.zip
To flash the firmware you need a blank micro SD card. Start by extracting ONLY the file named "UPD" to the blank card (ensuring this is the first file copied onto the SD card). Then you can extract the rest into the same directory. Make sure all files are in the root directory, and that there are no folders.
Make sure your unit is off. Insert the SD card into the GPS slot, then turn on the ignition and wait for the unit to turn on (or turn it on if it wasn't on before you pulled your keys out last time). Someone mentioned their unit was having trouble turning on - in that case unplug the radio fuse for a few seconds to fully reset the unit, then check that your unit can turn on, then do as above.
If you did everything right you will see a screen with colourful text appearing. Wait a minute or two and it will proceed to a white screen with text in the middle saying something about "updating MPU". In another minute this will turn to "MPU update success, please reboot". The unit will boot itself in a few seconds if you don't do anything. Regardless, just turn off the unit (don't start it yet) after you see that message.
Now, pull out the firmware SD from the GPS slot before starting the unit again. If you don't, it's not the end of the world, but the firmware flash process with the colourful text will start again from the beginning, and you have to wait for the full cycle to finish. If you start the unit without the firmware SD in the GPS slot, the unit will boot manually.
After the unit is fully booted into the radio interface, insert the firmware SD again, and it will ask you if you want to update the MCU. Choose yes and the unit will begin updating. In a minute or two the update will be complete and the unit simply shuts itself down. At that point the update process is complete, simply take the update SD out.
Last edited by DkN; 03-12-2013 at 10:50 PM.
TR 08 Golf GT TDI, Custom Code Phase 1, Milltek Exhaust, Whiteline RSB + ALK, APR Carbonio Intake
Bookmarks