Gen 2 Tiguan Wheels Thread

[tigger73]

Hey guys, quick question. Has anyone fitted A5 wheels to the gen 2 Tiguan? I’m looking at some 19x9 ET52. By my calculations, they should have the same poke as a set of 20x8.5 ET41 which are the standard Suzuka’s. The extra 0.5 inch goes on the inside of the the rim so i’m Hoping they won’t rub any suspension components. Any opinions comments appreciated Chris ����

These A5 wheels should be OK (depending on the tyres you want to run) but I would be looking at getting something with an offset around 35-40 if you had a choice. They will sit 4.6mm further inboard than your stock wheels and 17.4mm closer to your strut.

Stick the specs into an online calculator to see how the fitment looks: Audi A5 19" wheels vs. Suzuka 20"

[tigger73]

Right time for some more wheels...

[tigger73]

Some more inspiration

[tigger73]

And some more:

[tigger73]

OEM Savannah

[tigger73]

More wheels

[tigger73]

Some more OEM options - Cadiz:

[tigger73]

[REXman]

Some amazing wheels in this thread.

As a 162 tsi owner (non R line) with 18s stock, what size exactly Tyres and Rims do I want in a 20 inch wheel to keep close to stock rolling D.

And also how much drop do I need to half the stock 18s wheel gap. Thanks heaps


Sent from my iPhone using Tapatalk

[tigger73]

Some amazing wheels in this thread.

There's the good and bad all posted up without comment so that you can make your own mind up. Wheel selection is a very personal thing and it's one of the easiest ways to customise your car from an aesthetic point of view. Unfortunately I don't have specs on a lot of these, however for the genuine wheels you can probably work out what size/offsets they are running as there's generally only a couple of options.

As a 162 tsi owner (non R line) with 18s stock, what size exactly Tyres and Rims do I want in a 20 inch wheel to keep close to stock rolling D.

Stock tyre sizes in 20" are 235/45R20 (on 20x8 Kapstadt) and 255/40R20 (on 20x8.5 Suzuka).

However keep in mind that you'll need at least an 8.5" width rim to fit the 255 otherwise the bead may not seat properly in the lip of the rim and you will have more distortion/flex in the sidewall when cornering. A lot of tyre shops won't fit incorrect size tyres in case there is an accident an the cause is related back to incorrectly fitted tyres.

Personally I'd be going for an 8.5"-9" rim and run the 255/40R20 tyres as this is a more common size.

In terms of offsets because you run the standard (non R-line) wheel arch trims then you're a little more restricted in terms of aggressive offsets. My recommendation (based on experience) is to go 20x9 +35 or 20x8.5 +29 for near flush fitment.

If you're running the R-line wheel arches you can probably push the offsets another 8-10mm and still be "safe".

And also how much drop do I need to half the stock 18s wheel gap. Thanks heaps

I'm running the Eibach Pro-Kit (30mm drop) and I think they look good. I know H&R's do some 35 or 40mm drop however you will sacrifice some ride comfort for the extra 5-10mm. There's a number of guys from the US running stock Golf R springs and they lower it quite a bit more but then you'll more than likely significantly shorten the life of your shocks. Also not sure you'd want to do this with adjustable dampers.