Built in garage remote switch

[passat123]

Just seeing if anyone has installed a garage opener switch in their Mk2 Tiguan and can provide some photos/instructions.

I did this in my B7 Passat and wired it to illuminate when the accessories lights were on. Want to do the same in the Tiguan, just not familiar with this car and hope someone can help.

Cheers

Sent from my SM-S908E using Tapatalk

[Guest001]

I just mounted mine in the drivers side of the door pocket where it couldnt be seen DV52 did a schematic for one if I m correctly. Depends on the make of the remote

[passat123]

I was looking to replace a blank accessory button at the shifter location with a push button then wire a B&D remote internally and also have the button connected to the acc circuit

Sent from my SM-S908E using Tapatalk

[Guest001]

I was looking to replace a blank accessory button at the shifter location with a push button then wire a B&D remote internally and also have the button connected to the acc circuit

Sent from my SM-S908E using Tapatalk

Perhaps contact DV52 for the diagram Not sure if single buttons are available for the Tig Try Ali Express

[benough]

I was looking to replace a blank accessory button at the shifter location with a push button then wire a B&D remote internally and also have the button connected to the acc circuit

Sent from my SM-S908E using Tapatalk

I know this thread is quite old.

I put the TCS button into my Dad's MY20 R line, and wired it up that way.

[Guest001]

I know this thread is quite old.

I put the TCS button into my Dad's MY20 R line, and wired it up that way.

So it would be nice for others if you posted how you did it

[DV52]

^^^ I'm preempting @Hillbilly suggestion (of course) and I preface my response with the statement that I don't have access to the wiring diagrams for the mk2 Tiggy.

However, I did this very thing on mk7 Golf which shares the same DNA as OP's car (i.e. both vehicles are built on a MQB platform). Details about my approach can be found HERE.

As indicated in my explanation - my garage door controller was from Merlin (Chamberlain) - but this shouldn't matter because the integration of the switch on the remote to the car's button should be the same.

I built my solution with a simple multi-way plug/socket so that I could easily un-plug the device when I sold the car. It worked flawlessly for many years!!

Don

[passat123]

Appreciate it Don. Thanks for jumping in!

Sent from my SM-S908E using Tapatalk

[Flipper Dog]

Use the smart home option and convert your garage to WiFi, that way you can use your phone via Carplay/Android Auto to open it via voice as you approach the area.
Better option than mounting a hard button into the vehicle.

[benough]

Unfortunately I didn't take any photos.

I was echoing the post of passat123. You can get the part number for the TCS switch from ilcats.ru