Mk1 Front apron needs straightening - where can I go in Brisbane?

[Garbon]

Hi All

I have to get my front apron straightened on my Mk1. It was pushed in on the front LHS and was not repaired that well

Any ideas of people who know what they are doing with Mk1's in Brisbane?

Thanks guys

[roccodingo]

Fit a new section, available from richard at crazyquiff's...
http://www.golfmk1.co.uk/Details.php...ANELS&cat=body

[Garbon]

Hi Roccodingo

I need the full piece, how much would it cost to get one to Brisbane from the UK though?

Thanks

[Peter Jones]

I think Dom might have gotten one for his cabby from VW not too long ago.

Might be worth asking a dealership if they've still got the panel, the MK1 cabrios were around for years after the MK1s.


Pete

[Oneofthegreats]

Just beat me to it Pete!

Before you look at getting one from OS.

How about ringing a local VW dealer & seeing how much they are! I reckon you may be surprised.

I'm sure VW may still stock both the lower valance & also the complete Rad support under the Cabby versions!

[WABIT]

i paid $150 for mine, called up VW and they had it in stock, it was the lower apron skin where the lil spoiler attaches to

dom

[Garbon]

Hi Dom

Which VW dealer did you call as I tried Austral VW in Brisbane by e-mail enquiry and they said that they cannot get them anymore

Any part numbers or further details appreciated

Thanks Guys!

[Mrk_Mickey]

Hi Dom

Which VW dealer did you call as I tried Austral VW in Brisbane by e-mail enquiry and they said that they cannot get them anymore

Any part numbers or further details appreciated

Thanks Guys!

It might be worth mentioning to the next dealer that Mk1 cabrio's were produced until early 90's, and that they have the same part...that might change the no to a yes

[roccodingo]

Got a complete front panel of Tooleys a good few years ago also, could try them.

I only get stuff from UK cause I can get it cheaper from there to here than bringing it across australia.

[Garbon]

Hi Guys

I tried Austral VW in Brisbane and they said that the part is obsolete now

Roccodongo how much would it cost to get a new full front apron of rad support form the UK to Brisbane

Thanks