adjustable cam gear???

[deemoE36]

right...I sourced this autotech cam just recently,
what im after now is an adjustable cam gear


http://www.autotech.com/prod_engine_camgears.htm

has anyone had any experience with these?? any available to buy maybe

im after some feedback on these and on this autotech cam as well

cheers

[Mario]

Hi there.. yeh i had one on my MK1 years ago... I think i still have it at home? maybe?.. im pretty sure i didnt sell it... will have a look and let you know...

But yeh they are good... allowing a few degrees advance or retard..depending on what your after.. torque down low or up higher in the rev range.....

like i said will have a look 4 ya.. mario.

[deemoE36]

thanks mate...

did u use it wit an aftermarket cam or with stock

at the moment, this lumpy cam that i got is really good for the top end, but im not much of a rever so shifting the power down lower would be great for me

[BL33SU]

i'v seen on few peoples signatures with "muller adjustable cam"

is that from mullers at lakemba?

[Mario]

thanks mate...

did u use it wit an aftermarket cam or with stock

at the moment, this lumpy cam that i got is really good for the top end, but im not much of a rever so shifting the power down lower would be great for me

Hi there.. i used an aftermarket cam.. cant tell you the facts... Lift/duration as i cant remember.. but yeh, good power increase... I may still have the cam too.. i do remember seeing one a few weeks ago all wrapped up.. i take it you are after one for your MK1?.. are you going to run Twin side drafts or a single.... Single is better up to about 5500rpm, then you do see the diff with the twins above that too about 9000-9500rpm..
i used twin side draft 40mm delorto's... i should still have these somewhere too but i cant find them....ARRRRHHHH!!!.
mario

[DubSteve]

Deemo how much was your cam, jkust curious, I am looking into one for the vr6 where abouts did you get it from?

[deemoE36]

Hi there.. i used an aftermarket cam.. cant tell you the facts... Lift/duration as i cant remember.. but yeh, good power increase... I may still have the cam too.. i do remember seeing one a few weeks ago all wrapped up.. i take it you are after one for your MK1?.. are you going to run Twin side drafts or a single.... Single is better up to about 5500rpm, then you do see the diff with the twins above that too about 9000-9500rpm..
i used twin side draft 40mm delorto's... i should still have these somewhere too but i cant find them....ARRRRHHHH!!!.
mario

its a mk3, as u can see my power to weight is not the best, thats why i need that down low increse

Deemo how much was your cam, jkust curious, I am looking into one for the vr6 where abouts did you get it from?

swapt some parts with Matt, i would say $200 - 250 worth

[BL33SU]

man this cam stuff sounds good, was looking at the link u posted deemo.. looks cheap less than $200.. i need sme low end torque too

[DubSteve]

I'm looking at something like a 268 270 cam for the vr6. I got quoted 2200 bucks for a schrick one

[static1800]

go Autotech steve, get sports valve springs and the cam gear while your at it to