Audi S3 8P3 CustomCode Stage 2 PSS

[guile]

If you're after Goodyear F1A2's in 235/35R19 Goodyear Croydon in Melbourne has them for $1,020 for a set of 4. Shipping is reasonable - check the wheel and tyre thread for details. Rubal is your man!

thanks mate, i just called him, all gone. how hard is it to buy tyres...

[guile]

No worries, I thought you were chasing a semi slick? even the RS3 is borderline. I'd recommend a sticky tyre if you go stage 3 mate.

thanks al, stage 3 might not be until nearer the end of the year with the plans i have. saything that i hardly do any k's so might aswell get some now instead of buying tyres twice. any experaince with nitto nt05's? i know you get what you pay for but i'm also keeping in mind how much use my car gets...

thanks for the ongoing advice mate...

[tigger73]

thanks mate, i just called him, all gone. how hard is it to buy tyres...

Bugger!!!! But not really surprised given the price. He had 10 sets when I spoke to him a week or so ago.

Update: Rubal has another 5 sets arriving by the end of the week.

Sent from my iPhone using Tapatalk

[guile]

final piece to fix my antenna error code, hopefully get it installed when i'm back next…

[guile]

Bugger!!!! But not really surprised given the price. He had 10 sets when I spoke to him a week or so ago.

Update: Rubal has another 5 sets arriving by the end of the week.

thanks for the update mate, i spoke to him yesterday and he should have some more in by tuesday. had a call from the wheel refurb place yesterday and the wheels are now ready for the tyres so i'm keen as mustard to get the asym 2's...

[guile]

wheel refurb is complete and the tyres are on their way, whoop whoop...

[guile]

i managed to get the antenna sorted recently, started by removing the inner boot lid trim...



a quick shot of the original setup so i could remember how it was in case it all went pete tong...



the original unit in the top of the boot lid...



a quick shot of the wire colour coding...



and the colour coding at the bottom...



hooked up then new cable to test the length and make sure it reaches the unit in the bottom of the boot lid...



once i knew the cable was long enough it was time to make the basic loom...



a quick retest before i wrapped it...



once i knew it worked i wrapped both the new loom and extension cable...



and now all installed, looking pretty oem i reckon...



now it just needs resetting with vagcom and the fault code removing. no doubt i'll be asking another favour of mr walsh, please mate. and if the fault code comes back i'll cry...

[guile]

next up was the rearview camera...



a pretty tidy job...



i don't think its that obvious either...



and it works, just a bit of tidying up to do now then more coding (gavin)...

[h100vw]

next up was the rearview camera...
and it works, just a bit of tidying up to do now then more coding (gavin)...

Mid week mate

[guile]

next up was the rearview camera...
and it works, just a bit of tidying up to do now then more coding (gavin)...

Mid week mate

coolio, thanks mate. not back until the 20th though so will call you before then...

also need to install a relay switch to the reverse light to select between tv and reverse camera. my media controller is only basic, not basic plus which is why that switch didn't work last time...

and i've ordered a p3 cars gauge too so i will fit that all that jazz before i catch up with you in case i get any more codes. hopefully a reset will clear them all next time...

take it easy and catch up with you when i'm in bris...