Dylan, my BMWs rub on the front strut on the FWD at 9" et33 but not on the 4mo ;)
Printable View
Dylan, my BMWs rub on the front strut on the FWD at 9" et33 but not on the 4mo ;)
Yeah I'm not sure what the go is, I've seen a diagram that says they are the same up front
Concave Concept CC02 18x8.5, 18x9.5, 5x114.3, 5x100 S15 Skyline EVO GTR | eBay
dylan .... These should fit without any dramas ??
TheQuote:
Originally Posted by LeStig
??Quote:
18 x 8.5 +38, PCD 5 x 100 (Flat Black, Bronze)
Depends... Will fit rear fine.
Front will fit at stock height, lowered it may hit the strut
they also have the same wheel design at +35 but centre bore is 1mm too small.... i can get this machined to suit Bora so that shouldn't be an issue.
I'm running Bilstein B6 struts with lowered coils.... not coil overs .... so the clearance issue is likely to be what ? obviously the +35 is further away than the +38 but this is on a 9" rim so I'm overall worse off.... Correct ??
these are destined for a Bora 4motion ....
thoughts ??
Concave Concept CC03R 18x9 35 PCD5X100 Wheels FT86 BRZ WRX STI Forester | eBay
9et35 will be even worse on lowering springs. I imagine it'll hit the strut and poke.Quote:
Originally Posted by LeStig
The 8.5 et38 may clear the front struts if its just ~30mm lowering springs
17" x 7 Et 55 subaru liberty bbs wheels. I need spacers im looking at 25-30 mm will it fit. What size do you recommend. im on 35mm lowered springs
Stock was 17x7et38, so anything on that would be fine.
Check out pics of my abt v1s, they are 17x7.5 et30 with 215/45s.
If you did 30mm all round would be similar to that.
25mm front and 30mm rear with 225/45 all round should be fine
Thought ide post this just in case it helps anyone.
Currently I am. Running 18"x9"+38 and I have to run a 5mm spacer in the front to clear the stock strut. And I barely clear them. Literally. Have a fingernail between the wheel and strut. But no rubbing at all. Has done some very hard mountain runs. Only thing I chewed out where the front of the splash guards. And even that was very minor. But if I where going to buy another set of wheels. Ide go half an inch thinner and a bit less off set to be safe.
Sent from my One using Tapatalk
Put some pics up and add to the library Tim :)