This is the actual light and the company on the Gold Coast who I got it from .The fitting was a bit fiddly as I had to remove the whole front grill and lower bumper once removed it bolted straight onto the heavy steel support bar . Cutting out the part of the plastic grill was done a small bit at a time to make sure it fitted neatly . wiring was a breeze just ran the main power wire up to the battery and then fitted a heavy duty relay and soldered on to the high beam wire for a trigger , The wire trigger wire is routed through a simple switch to allow me to leave it off around town its just too bloody bright ! 12V 24V 144W 22 Inch Cree LED Work BAR Dual Beam Spot Flood Light 4x4 Offroad | eBay
Removed the bonnet holding rod and replaced it with the strut.
Sent from my GT-I9505
Last edited by Transporter; 02-11-2013 at 09:17 PM.
Performance Tunes from $850Wrecking RS OCTAVIA 2 Link
Bloody good idea !!
...and cheap mod as well. I have used a used bonnet strut from 1994 Wide body Camry, that I found in my shed. You can buy a new strut for around $30 with the 2 little ball joints (one only needed) that you screw in threaded hole that is already there, the thread is the same M8x1.25.
Last edited by Transporter; 03-11-2013 at 07:29 AM.
Performance Tunes from $850Wrecking RS OCTAVIA 2 Link
Thanks will do .
I was cleaning my shed and was about to throw that strut into the bin and the size of it reminded me that long time ago I looked at the option to replace that bonnet rod and the length was just perfect.
The last time I had to fix my van was 2-3 years ago, when the w/pump leaked.
The van is going so well now, that I want to keep it for another 10 years.
So, you may see a few mods to it.
Performance Tunes from $850Wrecking RS OCTAVIA 2 Link
Bookmarks