i think my steering rack is broken

[DVR68U]

hey guys after my weekend blast down to vic, i got to about 20ks from my house and slowed down to 60 and the steering started to get a killer wobble, i slowed down and checked it and i could find anything obvious, drove again and it does it up to 60ks then it stops once above that speed. but comes back when you slow down again. the next day i jaked up the car and the wheel bearings seem tight as do the wheels and the subframe. when i wiggle the wheel on the horozontal axis it seems there is abit on free play in the steering rack. i know that they can have racks wear out . does this sound like a typical case ? the tie rods dont seem to be the problem. any help would be great as ive got no cars to drive
cheers brenton

[Rebuild]

That's the genuine VW speed limiter for suburban areas kicking in

Just a thought,I had similar on a Mk1 Golf before one of the CV's let go

[h100vw]

Yeah might be driveshaft CV related. I haven't heard of the tie rods coming out of the rack.

The worst that I have seen is mega bad leaks.

Sure you've not lost a big balance weight?

Have you tried it on different roads, might be tarmac related? Like when you think a bearing has gone but it's just that you drove onto some different tarmac and the road noise changes.

Gavin

[Jmac]

The steering arm knuckles are bad for weariing on them. Had 1 wind out on a NSW ambulance. You buy the arms complete mate ive posted the part numbers on here before, let me check them again for you. ill post the numbers later. They are very common on T4.
CHeers

[DVR68U]

yeah its not tarmac related, ive driven on different types same prob, could be a wheel weight but wouldnt that get worst with increased speed? cv joints i dont notice any noises forward or reverse. when the van is jacked up there is play in the steering but the tierods seem to be tight, and the movement it back in the rack ?
cheers brenton

[Jmac]

The play you will find is in the knuckles right at the rack, get someone to rock the steering and feel inside the bellows. They are very common for play there mate.
See how you go
I dont doubt that the rack might have play too but just check them knuckles.
Cheers mate. swap your front wheels with the back too and see if it gets better that would rule ot your wheel balance mate
CHeers

[DVR68U]

alrite so how do you fix the play at the knuckles ? replace the arms is it a hard job, ive changed the whole subframe already not looking forward to taking it out again can they be replaced with the rack in the subframe still ?
cheers brenton

[Jmac]

Yes they can champ. A 38mm crows foot is the ticket. I have used stilsons in the past too. But to answer the question yes you can no worries.,done heaps probably done 50 % of the NSW ambulances.
CHeers

[Golf Loon]

I randomly scored some new genuine knuckles the other day too man, or rip the ones out of your scrap rack you have up there.

[DVR68U]

nice finally some good news in relation to my van haha.
so they can be changed, now i just have to have a look and get info on how to do it. so really i should change the tierods aswell while im at it.
cheers guys i was on a bit of a downer again with the van lol
cheers brenton