Hi all does anyone have knowledge of Actron Elite Auto Scanner , I have been loaned one with the view to purchasing it . So far I am a bit befuddled [everyone knows how I feel about technology ] Are VW,s so different that one of these wont work with it , the reason I ask is that today my wife experienced a loss of power after rounding a roundabout and then going up a slight uphill section . She admits in panic that she could not tell if the engine failed or just had no power suddenly , after turning it off and then on it started normally and drove home with no further problems . I attached this Actron unit via the OBD port but when I try to select auto ID for 2012 onwards it says the car does not support Auto ID , when you then go to manual selection it gives you three regions US Asia And Europe . Being a German car I selected EU it give a few models VW being one of them , then when you go to vehicle model it has Golf Jetta Tiguan and a couple of others but no Transporter / Multivan etc . Does this mean it wont work or something else , I ran a diagnostics using the parameters of a 2.0 litre Golf as a guide . It does see quite a lot of codes 329 to be exact but does not show any faults , I can see all sorts of engine outputs which means double dutch to me . Am I using it correctly or is it a waste of money , I tried it on my work van and it spat out 3 EGR codes that were faulty [tell me something I don't know as the engine check light has been on for the last 3 years or so ] I cleared those and the light goes out only to come back on ten minutes later ha ha . Now this what I was trying also to check on my van as well TCS and ABS fault lights have been off and mainly on for a few years also , but these do not show up as I was hoping it would show me if one of the ABS sensors on any wheel was a problem . Ok thanks in advance from a total tech failure ! Howard