any body got some pics of their t4 bullbar mounting points

[DVR68U]

hey guys a got a bullbar for my t4, i just have to come up with some mounts to get it on. maybe some of you guys that have bullbars could take a pic or to to show me what they have.
cheers brenton

[Seano]

You don't say what brand!

Mine is a Bocar and it is mounted across the main chassis rails (existing holes needed to be enlarged to 13mm) and to the bumper mounts just forward of the front wheel arches. In both instances, steel adapter mounts are used...and the bar bolts to these. From memory, the main mounts are U shaped steel section (one on each chassis rail) while the side mounts are flat bar with a hole in either end.

[DVR68U]

im not sure on the brand of the one i got , its all one piece alloy . looks alot like an 80series landcrusier tjm bar.

[Golf Loon]

I may still have the brackets for my bar at the workshop. The bar was weighed in for scrap, but the mountings were on the van for a year. They are not now, so are probably in a box. Yours if you can find em. They are basically L shaped angle pieces that bolt to the van and the bar bolts to them.

[DVR68U]

hmm that could be very handy , ill have to come down and have a beer/look next week.
cheers brenton

[Golf Loon]

hmm that could be very handy , ill have to come down and have a beer/look next week.
cheers brenton

Lol still lots of the beer in the fridge from pre nats Saturday

[soulspirit]

Does anyone else have a bullbar that they could share photos of? Are the stainless A-Bars any good? I need to mount my lights, and have been looking around for a bar that I could afford. Where did you get yours?

[Seano]

Does anyone else have a bullbar that they could share photos of? Are the stainless A-Bars any good? I need to mount my lights, and have been looking around for a bar that I could afford. Where did you get yours?

This one is from Bocar. I've just customised it by powdercoating it charcoal and welding in some security mesh to fill the roo sized hole that the lights also sit in.

As it is a three part bolt together bar (main bar + lower skirt + upper bar work) it can be customised. You can remove all the hoops and just leave the alloy bumper. Or you can get a smaller single hoop bent up and bolt that in.

There'll be a few out there on the used & abused market...

[DVR68U]

ill get some pics of mine once i get back from down the coast.

[soulspirit]

There'll be a few out there on the used & abused market...

I've been looking at one that is very similar if not the same. It is also very used and abused - that is 150 bucks. How much was the powder coating? I hadn't thought of that. Is yours alloy? It looks very nice.

This one requires a bit of powdercoating http://cgi.ebay.com.au/ws/eBayISAPI....m=220424622083