Printable View
Hi Tommie, I hope it's a simple fix, I can't be of much use to you, I'm way out of my depth with tuning K-Jet!
It sounds like Mtech knows a bit!
It's actually Potassium Hydroxide one step up from sodium hydroxide. some cleaners are a combo of both, with other additives to keep them in solution, and help with rinsing it off.Quote:
Originally Posted by roccodingo
Hi All,
Still no luck with the car. Running out of ideas....
Again the car starts, idles and revs without too much trouble . As soon as you stick it in gear and under loads the car conks out and doesn't want to run.
Things we've changed.....
1. New spark plugs
2. New rotor.
3. New Leads
4. New Fuel pump ( Bosch 044).
5. Set base ideal ( disconnect both vacuum lines).
5. Confirmed fuel pressure sitting about 4.5-5bar at idle and free revving.
6. Swapped Kjet fuel distributor.
7. Swapped Kjet injectors.
8. Swapped coil.
9. Fresh fuel in fuel tank.
And probably a lot more I can't remember.
Please let me know of any ideas.
You haven't got the timing out by 180deg?
Hi Tommie, I'm assuming the car wasn't running when you pulled the motor out?
It sounds like an ignition problem, I'd assumed that they were electronic dizzys, if so check the ignition module, if points check gap and points condition (I only added that because there was a points dizzy sitting in the rain tray of my GTI so now not sure if it's original to the car).
Cheers Scotty.
Nah,then it wouldn't run well without load, if at all.Quote:
Originally Posted by dubstar
Lucky 13 ( Dan) came around this arvo to help me work on the old girl.
We've decided to go back to basics and start at the beginning again.
Checked all 4 cylinders and all 4 checked out fine. Removed and checked spark plugs too.
Next we removed the rocker cover and it looked like we might be a tooth out. Got that sorted and did the timing again.
Few times up and down the street and we have the same issue.
Got it back in the garage, check timing again.
Next we removed the injectors and cranked the engine over to see how much each one is squirting.
Number 1 and 2 injectors had heaps of fuel and number 3 and 4 almost nothing. Seeing that the firing order is 1,3,4,2 that might be our issue. The fuel might be enough for idling and revving, but as soon as its under load it might not be enough.
Will definitely have another crack at it tomorrow........
Hey Tommie, after lots of thinking and reading over what you said a few times, I think the issue could be that there isn't a 20vt in there. Give that a try and let me know if it works out! Cheers
Hey Tommie......There's always one in every crowd!!:rolleyes::rolleyes::rolleyes:Quote:
Originally Posted by GeorgeMK1
Although.................It's a costly fix but it would solve the problem!
On a serious note I think you could be on to the cause. Leaning out under load could well cause the problem you've described. Just don't ask me to give any suggestions on why the K-Jet is doing it, other than a blocked line/s!!
Good luck, Scotty.
Check the fuel flow delivery rate from the pump. 30 seconds running should deliver 900 mls @ 11.3 Volts. The stuff you stuck in the fuel tank may have choked the outlet line from the swirl pot inside the tank.
Doing the injector test did you raise / lower the air metering plate several times ?? ( bleed any air from the system )
The metering head & injectors you swapped known good units ??