Bagged Bunny

[GeorgeMK1]

Im trying my best dan, its not easy with my little skills haha !!

Anyway wheels should be in tomorrow hopefully, stay tuned

---------- Post added 18-04-2012 at 07:08 PM ---------- Previous post was 17-04-2012 at 09:26 PM ----------

Soooo all my moneys gone lol.

Anyway was woken up by the delivery man this morning, i opened the door dead asleep, and ran out like i was being chased by wild dogs. Wheeeeels came in today

They are are BBS RS 14x6 with ET40 which is great for big lips. Tyres are 155/55 which are pertty damn rare to find too. Lips will be added later on in time, when i hit the lottery haha.


Heres me still asleep

[Jarred]

good work george!

make sure you take out seperate insurance on the wheels yea... lol

[BonsaiTiger]

sick wheels!! are these off Drewr on the other place? I made him an offer on them but it was a bit of a lowball. going to look mean!!

[GeorgeMK1]

So i just put them on for kicks to see what they look like, and even though they arnt dished and the car isnt lowered, i loveeeeed them !! Might cruise it like this for a while.

Also got some new banners to keep the motivation in the garage up

[GRN_VAGN]

They look lost inside those guards
Hurry and get some lips lol.

[ByronRichesMk1]

Looks sick George! Bet you're stoked as hell dude.
Contrast is pretty dope too surprisingly.
Where did you get that Pirelli banner from as well? If you don't mind me asking haha

[Preen59]

I like those wheels the way they are. Just needs to be a bit lower. Fit bigger tyres with a white or green pin stripe and they'd look mint I reckon.

[GeorgeMK1]

Byron my mates dad stole it from work for me hahaha

And preeny i think we're thinking in complete opposite directions hehehehehe !!

On another note, i blocked off the heater hole completely and began filler. Question i have is, what filler is best to use in the engine bay, ei, heat resistant, good adhesion etc ?

[Preen59]

Byron my mates dad stole it from work for me hahaha

And preeny i think we're thinking in complete opposite directions hehehehehe !!

On another note, i blocked off the heater hole completely and began filler. Question i have is, what filler is best to use in the engine bay, ei, heat resistant, good adhesion etc ?

Normal filler should be fine. You can also use seam sealer but it's harder to get flat..

[GeorgeMK1]

I decided to hop in the garage regardless of the non stop rain and freezing weather. Haha strangely enough the garage is warmer than my entire house! Ok so welded up the heater hole, and today had the journey of filling, sanding, filling, sanding, filling, sanding etc haha.

Also got a second hand parcel shelf thanks to Peter ! Its pretty good condition, but on the sides its got alot of wear. So i've decided to let my innovation fix it haha. Ill have it fixed in no time ! Thats all for today guys