Mine cost about 110$ (+$40 for a genuine VW bracket). Mine is a whole new pipe from the resonator back. I did it like this just incase I got a defect notice I could just bolt the old exhaust on, get the fault cleared and then haha make more noise again .
If you want to do it the real cheep way in sure it would cost about $50 just to chop the muffler off an put in a 40cm pipe...
CustomCode & Shark Performance does a stage 1 Remap for the 1.2TSI. I've gotten mine done from CustomCode - Acceleration vids here - Polo 6R 1.2 TSI DSG - Stage 1 Remap - 0 to 100 Acceleration - YouTube
New exhaust for 1.2TSI by Neuspeed - AUDI A1 VW POLO GTI(9N) / POLO(6R)専用ページ | フォルクスワーゲン・アウディ・ポルシェの専門プロショップ / イシカワエンジニアリング NEUSPEED日本総輸入元 (scroll down all the way to the end of the page)
BUT the exhaust costs a BOMB! ~ AUD$1400
Got the rear muff replaced with a small straight through one yesterday. After removing the stock one I did a quick lap around the block and while it was fun I think the novelty would wear off esp with the drone.
Now it is still pretty quiet but better tone and blurt...I reckon it sounds like a stock golf gti
MY18 Golf 7.5R - Ecotune Stage 1
Mazda RX2 - 13B Bridgeport GTX4202R
Bookmarks