Support VWWC

Page 373 of 736 FirstFirst ... 273323363371372373374375383423473 ... LastLast
Results 3,721 to 3,730 of 7352

Thread: What did you do to your Polo today?

  1. #3721
    Join Date
    May 2008
    Location
    Adelaide, SA
    Posts
    739

    Quote Originally Posted by philthy View Post
    What did they replace?

    Mine's always been a bit whiny.
    Bearings last time. Main shaft, First gear, and more bearings this time. Still feels exactly the same.

    Piss poor effort, especially after just 66,000kms.

    Oh, and by the way. Shocks wil last 60,000kms until they're not doing their job anymore. More than that and you're kidding yourself....
    Cheap, Fast, Reliable. Choose two.

  2. #3722
    Join Date
    Oct 2010
    Location
    Melbourne, VIC
    Posts
    3,178
    Users Country Flag
    It all depends on how hard they're worked - fully on competition rally driving would kill them in less than 5000km. That's why those guys use fully rebuildable dampers (with adjustment to allow for the wear before they get totally stuffed).

    Personally:
    Ordered my front spring distance kit.
    Did a genuine sub 4l / 100km along Beach Rd from Moorabbin => Port Melbourne with medium traffic - stick that up ya hybrid a$$, Prius

  3. #3723
    Join Date
    Feb 2008
    Location
    Sydney
    Posts
    2,756
    Users Country Flag
    I've got 90k kms out of my stock struts and they are still working fine. I have had Weitec springs since 13k kms. I have replaced my strut top bearings though, but my shocks still work quite well.
    I think my front sway bar rubbers are on their way out though.
    "If can't get behind your troops, feel free to stand in front of them..."

  4. #3724
    Join Date
    Oct 2009
    Location
    Canberra ACT
    Posts
    534
    Users Country Flag
    Im running Eibach springs. Had them in for roughly 50,000 km and had no problems

  5. #3725
    Join Date
    Oct 2010
    Location
    Melbourne, VIC
    Posts
    3,178
    Users Country Flag
    Right.
    And jesum killed his within 25,000 km when using aftermarket springs but the paved roads in Malaysia are a lot bumpier than the ones here (well, maybe not those in Nth Qld now).

    It's all about how hard they're worked and stiffer springs will work them harder so all other things being equal, aftermarket springs will cause the dampers to wear out more quickly than the standard ones.
    Combine aftermarket springs, bad roads and driving like a maniac all the time and you will get very short life from the dampers. Drive like a little old lady on good roads with stock springs and the dampers will last well over 100,000 km.

  6. #3726
    Join Date
    Jan 2009
    Location
    blankedy
    Posts
    4,058
    It's also about what people deem is satisfactory or stuffed. I could feel mine were not well after 10 thou k's with the H&R springs, they didn't dampen nearly enough when coupled with the Short coils.

    If I was on nice roads all the time I probably would have kept them, but they didn't soak up Sydney roads. Some of the MK6 guys are breaking rims on the NT roads, new suspension has come a long way to take that punishment to the rims and still be comfortable and low

  7. #3727
    Join Date
    Mar 2007
    Location
    Gold Coast
    Posts
    738
    Users Country Flag
    My polo has 95,000k's on it now on totally stock suspension. It still feels fine, but now that I think about it probably can't really remember what it was like new. Not too keen on stiffening it up too much, but I'd have to at least consider a set of matched springs/ shocks with a bit of a drop when I get around to replacing the dampers.

  8. #3728
    Join Date
    Oct 2010
    Location
    Melbourne, VIC
    Posts
    3,178
    Users Country Flag
    Quote Originally Posted by noone View Post
    It's also about what people deem is satisfactory or stuffed. I could feel mine were not well after 10 thou k's with the H&R springs, they didn't dampen nearly enough when coupled with the Short coils.
    Funnily enough, by using stiffer springs with OEM dampers, you are making the dampers closer to being stuffed from the outset, even before the accelerated wear, since you will be reducing the damping ratio by increasing the spring rate. So if you are performance rather than comfort, orientated, you are going backwards as far as wheel control is concerned, since fitting stiffer springs will immediately reduce performance and increase comfort from a damping perspective. The only gains are reduced body roll and lower center of gravity (assuming the stiffer springs are also shorter as they always are).

    Check the following excellent articles for what you need to aim for.
    http://www.optimumg.com/OptimumGWebS...Tech_Tip_1.pdf
    http://www.optimumg.com/OptimumGWebS...Tech_Tip_2.pdf
    http://www.optimumg.com/OptimumGWebS...Tech_Tip_3.pdf
    http://www.optimumg.com/OptimumGWebS...Tech_Tip_4.pdf
    http://www.optimumg.com/OptimumGWebS...Tech_Tip_5.pdf
    http://www.optimumg.com/OptimumGWebS...Tech_Tip_6.pdf

    Quote Originally Posted by noone View Post
    Some of the MK6 guys are breaking rims on the NT roads, new suspension has come a long way to take that punishment to the rims and still be comfortable and low
    Due to the damage from the flood/rain/cyclones, Nth Queensland is also experiencing this. But I doubt it's very comfortable when this happens and the drivers are probably just putting up with the discomfort in the bad stretches.

    Quote Originally Posted by philthy View Post
    Not too keen on stiffening it up too much, but I'd have to at least consider a set of matched springs/ shocks with a bit of a drop when I get around to replacing the dampers.
    Last edited by kaanage; 08-04-2011 at 09:49 AM. Reason: correcting poor grammar

  9. #3729
    Join Date
    Sep 2006
    Location
    Melbourne
    Posts
    2,344
    Ok

    Back to what you did to your polo.

    I recieved my Whiteline swaybar, which i purchased online. I opened it and no fitting kit, bolts etc, DOH

  10. #3730
    Join Date
    May 2005
    Location
    Point Cook, Vic
    Posts
    5,191
    Users Country Flag

    Quote Originally Posted by vwthunder View Post
    Ok

    Back to what you did to your polo.

    I recieved my Whiteline swaybar, which i purchased online. I opened it and no fitting kit, bolts etc, DOH
    Man.. The number of people i know that have been shipped the wrong or no hardware kit with their whiteline bars is amazing. You would have thought they would have done something about it years ago

    PERFORMANCE, STYLING AND OEM PRODUCTS FOR YOUR VW

    FOLLOW US ON FACEBOOK

Page 373 of 736 FirstFirst ... 273323363371372373374375383423473 ... LastLast

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
| |