Support VWWC

Page 25 of 48 FirstFirst ... 15232425262735 ... LastLast
Results 241 to 250 of 476

Thread: Louis19's Build Thread

  1. #241
    Join Date
    Feb 2014
    Location
    Gold Coast, Queensland
    Posts
    568
    Users Country Flag Thread Starter

    Louis19's Build Thread

    Decided to give the drags another crack tonight before I'm back at work next week. First run of the night I did a 13.3 which I was pleased with as it was already better than my PB leading into tonight.

    Few more runs in I had a cracker, 13.1 @ 106MPH. Had it of been winter weather with some cool air and less waiting around in between runs (was an event night so had to give way to all the bikes and dedicated drag cars), I believe a 12 sec pass could be realistic. Looking forward to winter. Louis19's Build ThreadLouis19's Build Thread

    Louis19's Build Thread-img_6121-jpg
    Last edited by louis19; 05-01-2017 at 02:36 PM.
    2006 GTI Polo - Big Turbo Build - Louis19's Build Thread

  2. #242
    Join Date
    Feb 2014
    Location
    Gold Coast, Queensland
    Posts
    568
    Users Country Flag Thread Starter
    A while back I had a stock manifold ported out like a lot of the guys in the UK do. It had been sitting on the shelf for a while, but finally got around to installing it last week. It had been well ported with a lot of the material in the collectors being removed and smoothed out. Install obviously meant dropping the turbo again, but once that was out, swapping the manifold over was a quick job.

    So by Saturday I had it all installed and had driven around to make sure it was leak free and running as it should. Initial impressions were as you would expect, a bit earlier spool up and mid-top end felt as though it's flowing a little more freely.

    Sunday was another rolling racing morning at QR so I figured it was a good opportunity to see how it feels WOT down the straights.

    Here's a vid from my races on the day and a few pics I got from the install also. I tried to get a pic of the difference before and after porting but the pics don't do it justice as to how much has been removed.

    Anyways, Enjoy Louis19's Build Thread

    https://youtu.be/VHQRTu1VokE

    Louis19's Build Thread-3c73cbdc-ade3-4265-8702-8b75e3fcc8ed-jpg
    Louis19's Build Thread-img_6336-jpg
    2006 GTI Polo - Big Turbo Build - Louis19's Build Thread

  3. #243
    Join Date
    Feb 2014
    Location
    Gold Coast, Queensland
    Posts
    568
    Users Country Flag Thread Starter

    Louis19's Build Thread

    Another rolling racing day, another vid. Went back to race a few mates I had raced previously to see if there was a difference on track. Loads of racing in this one, 30+ races. Best race of the day was the white A45 AMG with an intake and exhaust. The Neck and neck races had us both laughing afterwards and the "TDI" badge collected a lot of attention from the competition.

    https://youtu.be/XQ5yuz_eC_o

    Louis19's Build Thread-img_6424-jpg
    Last edited by louis19; 07-02-2017 at 06:59 PM.
    2006 GTI Polo - Big Turbo Build - Louis19's Build Thread

  4. #244
    Join Date
    Sep 2013
    Location
    nsw
    Posts
    3,215
    Users Country Flag
    Got a question about your launches. I know it'd probably be different for you with the K04 compared to my K03s, but are you using a lot of clutch slip throughout 1st gear to prevent wheelspin?

  5. #245
    Join Date
    Feb 2014
    Location
    Gold Coast, Queensland
    Posts
    568
    Users Country Flag Thread Starter

    Louis19's Build Thread

    Quote Originally Posted by sambb View Post
    Got a question about your launches. I know it'd probably be different for you with the K04 compared to my K03s, but are you using a lot of clutch slip throughout 1st gear to prevent wheelspin?
    Only for the first few metres or so then I drop the clutch and just feather the throttle to maintain reasonable grip until 2nd gear. Once into 2nd and the spinning stops it's foot to the floor. It's a fine line between spinning a little bit, and just free spinning on the spot. If I don't get the launch right I just putt down the strip because you know you're not going to get a good time if you stuff the first 60ft, but the last time out all my 60ft times were 2.2 or lower.

    Next time I go I'll setup the camera so you can see/hear it from inside the car.
    Last edited by louis19; 08-02-2017 at 03:53 PM.
    2006 GTI Polo - Big Turbo Build - Louis19's Build Thread

  6. #246
    Join Date
    Sep 2013
    Location
    nsw
    Posts
    3,215
    Users Country Flag
    ok cool. that's what I've been doing too. I start with the clutch held at the bite point, loaded up against the handbrake at about 2500rpm. I've just changed to soft compound semi's so i'll probably need more launch revs to stop it bogging. we'll see I guess. thanks mate.

  7. #247
    Join Date
    Feb 2014
    Location
    Gold Coast, Queensland
    Posts
    568
    Users Country Flag Thread Starter
    Quote Originally Posted by sambb View Post
    ok cool. that's what I've been doing too. I start with the clutch held at the bite point, loaded up against the handbrake at about 2500rpm. I've just changed to soft compound semi's so i'll probably need more launch revs to stop it bogging. we'll see I guess. thanks mate.
    No worries mate.

    That should certainly help a fair bit. Also bare in mind that I would be dropping my tyre pressures a lot more at the strip than what you would be for hill climbs around going around corners. Think I had my fronts at just under 20psi last time I was out there.
    2006 GTI Polo - Big Turbo Build - Louis19's Build Thread

  8. #248
    Join Date
    Feb 2014
    Location
    Gold Coast, Queensland
    Posts
    568
    Users Country Flag Thread Starter

    Louis19's Build Thread

    Hey guys, little while since I posted. I went out to QR again on the weekend with downshift and a large Vw group had organised to attend so I got a few of the polo guys together as well to join them. Was a fun morning having good mates and fellow polo drivers to muck around with out there.

    Here's a quick vid of what we were up against. I think I lined up nearly every Vw out there.

    To give you a gauge of the pace of the different cars, the white MK6 GTI at the start is stage 3, the grey TTRS is Stage 1 with water meth. All of the rest of the vw's varied from stage 1-3 as well.

    https://youtu.be/v-jq2SgKnac
    2006 GTI Polo - Big Turbo Build - Louis19's Build Thread

  9. #249
    Join Date
    Aug 2006
    Location
    Melbourne VIC
    Posts
    6,784
    Your car is an animal!

  10. #250
    Join Date
    Sep 2013
    Location
    nsw
    Posts
    3,215
    Users Country Flag

    was that the red devil out there too?

Page 25 of 48 FirstFirst ... 15232425262735 ... LastLast

Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  
| |