Mk6 LED Taillights

[slipshot]

Chaps

A question relating to putting standard lights BACK on the car after removing LED's - is the standard hex for Byte 18 00 and thus standard binary 00000000?

Only I need to turn my MY10 with halogens back to standard and of course stupidly did not record what the original was? I assume 00 if the default though?

Thanks

[AdamD]

Figured it out, son of a B****!!!

The wiring adapters provided were wired up BACKWARDS!..

Certainly sounded like a hardware/wiring issue. Good to hear you got it fixed up.

[AdamD]

Only I need to turn my MY10 with halogens back to standard and of course stupidly did not record what the original was? I assume 00 if the default though?

Most I've seen are 00 before being coded.

[kryten2001]

Most I've seen are 00 before being coded.

Mine were coded 02. I made a special point to check this just in case I had to ever set them back.

[Ozram]

Chaps

A question relating to putting standard lights BACK on the car after removing LED's - is the standard hex for Byte 18 00 and thus standard binary 00000000?

Only I need to turn my MY10 with halogens back to standard and of course stupidly did not record what the original was? I assume 00 if the default though?

Thanks

When I did mine I went in and selected C0 Lighting : Reset from the drop down box. I left it at that and all the lights worked fine. In hindsight I think I should have reset and then gone back in and recoded to option 02 like kryten2001 said. (see below)

[slipshot]

Just to confirm.

I reset it to 00 (Co Lighting reset) and it worked fine - and then I checked the rear lights, and the two inner ones were far brighter than the two outer ones (or vice versa) but an obvious difference.

I then reset it to 02 and all worked fine and back to normal. Thus I would suggest for those resetting there's that 02 should be the first point of call...

[vwgtimk6]

with out having to read this whole thread,

what is the cost shipped to brisbane?

[Ozram]

with out having to read this whole thread,

what is the cost shipped to brisbane?

No.... No clues!!!

You must read the whole thread to qualify for that information.

[MovieDude]

Are these legal in Australia and if so where can I get them in Perth and are they easy to fit?

[AdamD]

Just to confirm.

I reset it to 00 (Co Lighting reset) and it worked fine - and then I checked the rear lights, and the two inner ones were far brighter than the two outer ones (or vice versa) but an obvious difference.

I then reset it to 02 and all worked fine and back to normal. Thus I would suggest for those resetting there's that 02 should be the first point of call...

I would suggest you take note of what your original coding was when you change it (as is advised by Ross-tech whenever making a coding change), and restore to that!